Measuring for Rod Length
Enter the desired length of the rod, finials NOT included. Be sure to measure in a straight, level line—keeping your tape measure parallel to the floor.
Overhang
Be sure to consider your desired overhang on each side of your opening. Overhang is the amount the rod extends past the opening (not including finials). It provides a more polished, professional look.
- 4–12" recommended per side
- Improves professional finish
- Inset brackets 2–4" from finials for balance
Keep in mind that in most cases you’ll want to place your end curtain brackets 2–4" in from the drapery finials. This positioning allows space for a few grommets or fabric panels outside the end brackets, ensuring the brackets remain hidden and the drapes hang naturally.
If using finials
Make sure there will be adequate room for both the rod and the finials in the mounting area.
Please Note: The measurement you provide for the length of your rod is the measurement of the rod only (NOT including finials.) The finials will extend out beyond this length. Ex: If you order a rod at 48", and finials which are 3" each, your total length with finials will be 48 + 3 + 3 = 54". This is true regardless of the type of rod or finial. Rod + Finials = Total Length
If using socket brackets
If using socket brackets, make sure to subtract 7/8" from the length of the rod to allow room for the brackets. (The backplates are 3/8" thick each, so 7/8" gives room for two brackets plus 1/8" for wiggle room.) Err on making the rod too short, as leaving the rod too long will prevent installation or require you to cut the rod.
- Measure the desired finished length of the rod (finials NOT included) — measure straight and level and record that value.
- Subtract 7/8" (bracket allowance) from your measured desired length to get the rod length to order/cut.
- 60" = 59 8/8"
- 8/8" − 7/8" = 1/8" → result = 59 1/8"
- So order 73” rod and cut it down to 59 1/8"
- Final check: re-measure the opening and ensure the calculated rod length fits the installation plan.
- Example: If desired length = 60":

